User manual

5
Using The Eclipse Dowser
The Eclipse Dowser is a member of the Coloram II family of products and operates from
the Coloram II Power Supply. See the Specification section of this manual for detailed
dowser information.
Channel Setting
Each dowser is assigned a DMX address to which it will respond. The DMX addresses
are set via the rotary switch and third DIP switch located on the bottom of each dowser
in combination with the Coloram II Power Supply starting DMX channel. Valid DMX
addresses are 001- 512. The dowser uses one DMX channel.
Set the power supply starting DMX channel by using the SETUP menu. This is the first
channel in a block of consecutive DMX channels assigned to that power supply. The
channel numbers assigned to, or designated for, the dowsers will be within the lower
half of the block of DMX channels displayed at the power supply.
Note: See the Coloram II User Manual for more information on the power supply and
channel setting.
Set the channel for each dowser by using the rotary switch and third DIP switch. The
switch settings and the 24 channels they represent are as follows:
Rotary
Switch
DIP Switch
#3
Dowser channel
1
1-12
1
2
1-12
2
3
1-12
3
4
1-12
4
5
1-12
5
6
1-12
6
7
1-12
7
8
1-12
8
9
1-12
9
A
1-12
10
B
1-12
11
C
1-12
12
1
13-24
13
2
13-24
14
3
13-24
15
4
13-24
16
5
13-24
17
6
13-24
18
7
13-24
19
8
13-24
20
9
13-24
21
A
13-24
22
B
13-24
23
C
13-24
24