User manual

3
Introduction
The Coloram II System consists of mechanical dowsers, scrolling color changers, gobo
changers and power supplies in a complete range of models offering ease of setup and
use.
The lightweight dowsers and color changers slide easily into the gel frame holder of the
light fixture. The compact Coloram II Power Supply attaches easily to the truss of the
lighting rig or mount into a 19-inch rack.
The DMX512 control signal from the lighting board is connected to the power supply
and can continue on to more Coloram II Power Supplies or other DMX controlled
devices. The power supply sends both power and control signal on a single cable
eliminating the need for a separate power cable for each dowser.
The Coloram II System is equipped with the Intelligent Diagnostic System (IDS). Status
information is sent from each of the Eclipse dowsers and Coloram II Color Changers to
the Coloram II Power Supply.
Caution: The Coloram II System is not compatible with the Forerunner
System. Do not connect Coloram II Color Changers to Forerunner Power
Supplies, or Forerunner Color Changers to Coloram II Power Supplies.
Damage from such action will not be covered by the Coloram II or
Forerunner warranties.
Getting Started Quickly
Channel Setting
Set channels as follows for operation on DMX channel 1:
1. Set the Coloram II power supply starting channel to 1
2. Set the Eclipse dowser rotary switch to 1
3. Set the Eclipse dowser DIP switch #1 to DMX control
4. Set the Eclipse dowser DIP switch #3 to CHANNEL RANGE 1-12
Cable Connections
1. Connect the Eclipse dowser to the Coloram II Power Supply
2. Connect the Coloram II Power Supply to the DMX source