User manual

Specifications

Vane speed (under DMX control):

-- fast cut: 200 milliseconds (fully open to fully closed and visa versa)

-- strobe rate: 100 milliseconds (60% amplitude)

-- cross fade: up to 60 seconds (movement without stopping)

Operating modes:

1. DMX512

2. Local wired pendant control

3. Local push button control (push buttons on the dowser unit)

Number of DMX channels used:

-- one

LED Indicators:

1. Yellow -- DMX or Local control

2. Red -- reserved

3. Red -- low voltage (less than 22 VDC)

4. Green -- power

5. All flashing -- shutdown

DIP Switch Functions:

1. DMX or local control

2. Snap Mode ON / OFF

3. Channel Range 1-12 or 13-24

4. reserved

Control Pendant 3-pin XLR connector pin functions:

-- Pin 1 -- connect to common to open the vanes

-- Pin 2 -- connect to common to close the vanes

-- Pin 3 -- common

Current Requirements:

-- 0.25 amp average @ 24VDC

-- 1.0 amp peak @ 24VDC

Fuse:

-- 1.5 amp Slo-Blo

Mounting Plates:

-- various plates available to fit a wide variety of fixtures

Wired Pendant control cable:

-- 3 conductor with 3-pin XLR connectors

-- up to 1000 feet long

Fan:

-- small, low speed fan to cool the electronics enclosure

Safety Cable:

-- 3.5 feet long cable included

Daisy Chaining:

-- individual ID's on one home run

Power Supply Compatibility:

-- Coloram II Power Supply only

Signal Termination:

-- none required