r Owner's manual



WhitePaper–NetworkingwithEclerNetManager

Document:AS Version:1.0 Date: Page4 of12

 PC DEVICE

IPaddress 10.0.0.2 192.168.0.100

Mask 255.0.0.0 255.0.0.0



Acrossinternet,therearealotofnetcalculatorstobringthecorrectconfigurationinaneasy

way.

Asagoodstartingpoint,itwouldbestronglyadvisabletocheckthecontrollerdeviceIP

(computer)andthecontrolleddeviceIP(Eclernetworkabledevice).Asimplewaytodosoin

Windowsisusing“ipconfig”command.OpenaCMDwindowand write“ipconfig/all”(without

quotes);youwillascreenshowingthePCnetworkconfiguration,similartothis one:



Thisconfigurationmus tbecompatible (IPrange,mask)withthecontrolleddevice.Inthis

example,assumingwehaveanIP:10.0.0.175andmask:255.0.0.0,themanuallyentered

networkconfigurationforthecontrolleddevice(inthiscaseaMIMO88)couldbethisone:



NotethattheIPGatewayisnotconfigured

andleftbydefault,sincewedon’tneedtoreach

controlfromlocationsoutsideourlocalnetwork.