r Owner's manual




WhitePaper–NetworkingwithEclerNetManager
Document:AS Version:1.0 Date: Page11 of12


 Youwillthengetintocontrolmode(greenconnectionicons):


Inallthesituationswherearouterorafirewallisinvolved,besurethattheinitiatingUDPport
(2210bydefault)isopened.Beespeciallycarefulifyouuseasoftwarefirewall.Thebestway
todealwiththis,ifyoucanafford,istodisablethesoftwarefirewall
andrelyonaspecialized
hardwarefirewall(Juniper,Cisco…).
Finally,takeintoconsiderationthatTP‐NET(Ecler’sthird‐partyremotecontrolprotocol)uses
alsoUDP,inthiscaseatport5800.Ifyoumakeuseofthisprotocol,ensurethesamecareis
takenwithport5800asdescribedabove
forport2210.Obviously,noneoftheaboveistobe
appliedifyoucontrolthedeviceviaRS‐232.


