Technical Specifications

Technical
Data Sheet
E6000 PLUS ADHESIVE
Clear
E6000 PLUS| USA/CAN/EU/ME/AU/NZ | Rev 00 – Effective: 2018 AUGUST/ Approved: 35TMorgan/ R&D Page | 2
CANADA
56.1 mL & 26.6 mL
DIRECTIONS and APPLICATION NOTES
Read directions and test small area for adhesion before use. Surface should be clean, dry
and free of dirt. For best adhesion on smooth, non-porous materials, lightly roughen surface
before use. Ideal application temperature range is 50 to 90 ºF (10 to 32 ºC). Once fully cured,
the adhesive can withstand. Temperatures from -40 to 200 ºF (-40 to 93 ºC) intermittently.
1. Puncture seal in neck of tube using pointer cap.
2. Apply directly to surfaces to be bonded or repaired. NOTE: For non-porous surfaces,
apply adhesive, mate surfaces together, pull apart for 5 minutes, then re-mate surfaces
permanently.
3. Remove air in the tube by squeezing product slightly past end of the opening, then
tightly recap. Dried product can easily be removed.
4. Allow 24 hours for full cure. Depending on substrates and temperature, maximum bond
strength may not be reached for up 72 hours.
5. Clean uncured adhesive with rubbing alcohol, mineral spirits, acetone or a dry cloth.
Cured material may be removed with mineral spirits or by cutting or scraping.
TIP: For quick emergency repairs, lightly mist the substrate with moisture prior to applying
adhesive.
Not recommended for use on acrylic, vinyl, foam, polyethylene and polypropylene. Store in a
cool, dry place.
SANDING DIRECTIONS: E6000 PLUS sands easily. The cured adhesive sands off at different
rates depending on grit of sandpaper. Carefully cut away as much cured excess as possible.
Use the coarsest grit (example 60 or 80) sandpaper to eliminate the excess. Then, a finer grit
(example over 200) sandpaper for finish work.
RETURNING CURED ADHESIVE TO ITS ORIGINAL CLARITY: If the cured product is left in a dark
environment for a lengthy period, it may yellow. The cured material can be returned to its
original clarity by setting it directly in natural (UV) light.
APPLICATION TO WET SURFACES: For quick emergency repairs, lightly mist the substrate
with moisture prior to applying adhesive. Application on damp and wet surfaces may slightly
affect adhesion.
LIMITED WARRANTY
The product is warranted against any defect in materials or workmanship under normal use for a period of 180
days after the date of purchase. The product is also warranted under any implied warranties provided under
applicable law, including, without limitation, the implied warranty of merchantability and the implied warranty
of fitness for a particular purpose, for a period of 180 days after the date of purchase. The manufacturer will
not accept liability for more than product replacement. This warranty covers only the original buyer of the
product. For warranty service, the buyer should contact the store where the product was purchased, or write
Eclectic Products LLC, P.O. Box 4450, Pineville LA 71361 or call 800.767.4667. Our goods come with guarantees
that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure. This warranty gives you specific legal rights, and you also have other rights, which
vary from province to province.