User's Manual

iv
Introduction
The SKANTI
®
Scansat-7701 is a single-channel Iridium
®
satellite
system designed for the harsh sea environments with professional
mariners and serious yachtsmen in mind.
The SKANTI Scansat-7701 conform to all relevant international
requirements.
The SKANTI Scansat-7701 system consist of a compact Transceiver
Unit (ITU 7701), a small Antenna Unit (IAU 7701), and a Control Unit
Handset (ICUH 7701).
The Control Unit ICUH 7701/ICUD 7701 with display and keypad is
used for controlling the "black box" Transceiver Unit and the remote
Antenna Unit facilitating installation. The SKANTI Scansat-7701
Iridium telephone offers both telephony and data transmission at
2,400 bit/s.
The SKANTI Scansat-7701 Iridium system provides flexible installa-
tion:
- Up to 100 m between the Control Unit and
the Transceiver Unit
- Up to 50 m between the Transceiver Unit and
the Antenna Unit depending on cable type.
The SKANTI Scansat-7701 standard power supply is 10-32 V DC,
optionally 110-230 V AC (external adaptor).
Important!
For FCC RF exposure compliance, the antenna must be
installed with a minimum distance of 0.61m (2 feet) away
from all persons.
About this Manual
This manual provides instructions on how to operate a control
handset and telephone.
Basically, the manual consists of two main parts: The first deals with
simple operation, which includes e.g. making and answering calls.
The second part describes the more advanced functions of the
system.
All functions of your Iridium equipment can be tested by following the
step by step procedures described in this manual. Each procedure is
an explicit sequence of key presses that has to be carried out.
Unless otherwise specified, the description of the individual proce-
dures has been based on the assumption that the CU is enabled and
has returned to idle state. See section “Handset Enabling/Disabling”
under “Handset Simple Operation” on how to enable and disable the
handset.
0303
Returning to Idle State on an Enabled CU:
1. Press
, if necessary, a number of times until one of the
following idle texts are shown in the display:
• Ready
• Occupied
• Internal Call
• External Call
• Locked
and possibly time, date and time or position depending on the status
of your Iridium equipment. Alternative idle texts are specified in
section “SIM Card Messages” under “SIM Card Handling”.
2. Make sure that the CU is hooked on. Place the handset in the
cradle and press
if the icon is shown in the
display.
We recommend that you read the manual before using the equip-
ment.
Please note
Any responsibility or liability for loss or damage in connection with
the use of this product and the accompanying documentation is
disclaimed. The information in this manual is furnished for informa-
tional use only, is subject to change without notice, may contain
errors or inaccuracies, and represents no commitment whatsoever.
This agreement is governed by the laws of Denmark.
Doc. no.: B4155GB9 Issue: E/0303