User guide

56
8. Remote Control TV Codes
Programming the Remote with Control Codes
Search the table in this section for your TV manufacturer. Make a note of the
control code (or codes) used by the manufacturer. Use the following procedure
to program your remote control:
1. Press and hold both the TV and OK keys on the remote control for at
least 5 seconds. The Main Menu button will illuminate.
2. Using the numbered keys, enter the 3 digit code listed for your make of
TV.
3. The Main Menu button will flash once and remain lit.
4. Press the OK button.
5. The Main Menu button will flash 3 times and then turn off to confirm
programming is complete.
6. Press the TV button to test if your TV can be switched on and off.
If the manufacturer uses several codes, you may need to repeat the sequence
until you find the right code.
Scanning through Control Codes
If the manufacturer of your TV is not listed, or the specified code does not work
use the following procedure to scan through all programmed remote codes.
1. Press and hold both the TV and OK keys on the remote control for at
least 5 seconds. The Main Menu button will illuminate.
2. Press CH+ or CH- until your TV turns on.
3. When your TV switches off, press OK to store the code.
Tip. If neither of these methods is successful, please try the learning mode
(see page 23).