User guide

15
3. Getting Started
Before you switch on the power to your HDS-600RS, check the following:
 Have you put batteries in the remote control (see page 11)?
 Is the unit connected correctly (see page 10)?
 Is the TV switched on?
Switching on for the First Time
Press (On/Standby button) either on the remote or on the front of the unit.
The HDS-600RS may take up to a minute to power up the first time.
When initialisation is complete, the Setup Wizard is displayed. This will guide
you through the process of setting up your satellite signal and detecting
freesat channels.
Follow the on-screen instructions to set up your HDS-600RS.
Press OK to start the installation process.
Note. The HDS-600RS will start the installation process when it locates the
home transponder – this may take several minutes