Operation Manual

Description and Operation

www.echostar-int.com Page 2 - 13

Installation setup Program SAT

1. SAT To define the satellite you want to search channels on. For motorized systems, allow the dish

some time to move to the selected SAT until the signal indicator shows a reading.

Red: Direct access to the edit menu; to add/edit a satellite that is not listed.

2. Longitude (Motorized only); To define the orbital position of the defined SAT.

3. LNB To define the LNB that you use in your system.

Red: Direct access to the User LNB menu; to add a LNB that is not listed.

4. TP Shows a transponder, from the internal database, of the defined SAT. If the signal indicator

shows low levels, select another TP that gives a better signal.

Green: Direct access to the edit menu; to add/edit a transponder that is not listed.

5. Search mode To define the required search mode for a full, update or limited search.

Search channels Search channels does a channel search on the defined SAT.

Wait until the signal indicator shows a reading, before you press the OK key to continue.

Installation setup Edit

1. SAT To define the satellite you want to edit.

Red: to add a satellite that is not listed.

Green: to edit the selected satellite.

2. Longitude To define the orbital position of the defined SAT.

3. Frequency To define the Frequency of the transponder.

Red: to add a Frequency that is not listed.

Green: to edit the selected Frequency.

4. Polarity To select Horizontal or Vertical polarity.

5. Symbol rate To define the Symbol rate of the transponder.

6. Channel To define the name of the channel.

Red: to add a channel that is not listed.

Green: to edit the selected channel name.

7. Video PID To define the Video PID of the selected channel.

8. Audio PID To define the Audio PID of the selected channel.

9. PCR PID To define the PCR PID of the selected channel.

Confirm To save the settings and return to the sub-menu banner.