Operation Manual

Description and Operation
www.echostar-int.com Page 2 - 9
© 2004 EchoStar International Corporation
All rights reserved
9. SOFTWARE UPGRADE - FACTORY RESET
IF YOU WANT TO DO A SOFTWARE
UPGRADE BY OTA:
1. Press the MENU key and
select the Installation setup -
Software upgrade.
2. Select the applicable
OTA setting.
3. Make sure the signal
indicator shows a signal.
4. Select Start.
5. Press the OK key to start the
procedure:
a. the TV screen turns
black:
b. If the there is no new
EchoNAV version,
nothing happens.
c. If a new EchoNAV version
is found on the satellite,
the receiver starts to
download the new
EchoNAV version. This
process can take up to
approximately
30 minutes.
6. The Software upgrade is
completed when the TV
shows live video.
I
F YOU WANT TO DO A SOFTWARE
UPGRADE BY PC:
1. Press the MENU key and
select the Installation setup -
About EchoStar.
2. Look up the current:
a. EchoNAV version.
b. Internet site.
3. On your PC with Internet
access, visit our Internet
site.
4. Go to the Product support
area and find the software
for your receiver.
5. Download the latest software
as applicable for your
receiver.
6. Find the utilities link and
download the EchoNAV
loader.
7. Follow the instructions as
given in the zip-file.
8. Note that on our Internet
site, a new manual update is
available to cover the latest
features.
IF YOU WANT TO DO A FACTORY
RESET
(required if you want to change
the system type, recommended
after you cannot resolve any
problem):
1. Write down the most
important settings before
you Confirm the Factory
reset (e.g. Switch and Port
settings, LNBs, User
preferences, etc.).
2. Press the MENU key and
select the Installation setup -
Factory reset.
3. Select User settings: Yes.
4. Select Confirm.
5. Press the OK key to start the
procedure:
6. Continue with the initial
installation to install your
receiver.
MENU key - Software upgrade by OTA.
RS-232 cable - Software upgrade by PC.
MENU key - Factory reset.