Operation Manual

Section 7 Troubleshooting
Page 7 - 2 EchoStar DSB-707 FTA
© 2001 EchoStar International Corporation
All rights reserved
2. Bad picture or noisy
sound in the TV or radio
mode.
■ Bad reception of the
signal.
■ Make sure the dish and
LNB are clean and
correctly adjusted. Do
any necessary work.
■ Signal interference with
UHF-installation.
■ Check the UHF settings.
Make sure you use the
correct channel. Please
refertotheTV/radiouser
guide.
3. The TV shows a
No Signal message.
■ Bad reception of the
signal.
■ Make sure the channel
selected transmits.
■ Make sure the correct
dish or LNB is selected.
■ Make sure the dish and
LNB are clean and
correctly adjusted. Do
any necessary work.
4. There is no Dolby digital
(AC-3)soundtomyother
equipment.
■ The equipment is
connected to the receiver
with a RCA or SCART-
cable only.
■ Connect the
S/P DIF connector of the
receiver to the Dolby
digital input of the
receiving equipment.
5. I can not view or listen to
a scrambled channel.
■ The receiver is FTA only
which means that you
can not view scrambled
channels.
■ Thereisnosolutionfor
this.
6. I cannot find a channel
which should be there.
■ The group or sort option
is set.
■ Set the group and sort
mode to none.
■ Youareinthewronglist. ■ Check the all channels
list and select the correct
(favorite) list.
■ The channel is hidden. ■ Unhide the channel.
7. The TV shows a popup:
■ You have selected an
empty (favorite) list.
■ Press the WHITE key
Select the add option.
■ Press the GREEN key
Select the Current Sat or
All Channels list.
Problem Possible cause What to do?
Downloaded from www.Manualslib.com manuals search engine