Operation Manual

Section 3

Installation

Page 3 - 2 EchoStar DSB-707 FTA

2. CONNECT A DISH

It is possible to connect the different dish configurations with the use of RF coaxial cables.

Only the most common configurations are discussed. If in doubt, please ask the EchoStar

service department for advice.

1. On the dish installation, connect a RF cable (for detailed instructions, refer to the

manufacturer’s instructions).

2. On the rear panel of the receiver find the LNB IN (digital) and the IF OUT connectors

FIXED DISH INSTALLATION WITH LNB(F)

3. Install the F-connector (dish) to the LNB IN connector (receiver).

FIXED DISH INSTALLATION WITH DISEQC SWITCH

3. Install the F-connector (DiSEqC switch) to the LNB IN connector (receiver).

WARNING

ALL EQUIPMENT INVOLVED IN THE INSTALLATION TASK MUST BE INSTALLED CORRECTLY

ANDSWITCHEDOFF

.MAKE SURE THAT IT IS SAFE TO PROCEED WITH THE INSTALLATION

TASK

.UNSAFE CIRCUITS AND INSTALLATIONS CAN CAUSE (SERIOUS) INJURY OR DAMAGE

TO EQUIPMENT

CAUTION

Tighten the cable connectors only by hand. Do not use any tools. You will damage

the connector pins if you overtighten the connector. This will result in loss of signal

quality, or even total loss of reception.

Downloaded from www.Manualslib.com manuals search engine