User's Guide

SETUP AND INSTALLATION
This allows you to set-up and control multiple sensors using Zigbee signals that communicate with your SAGE Hub and that you can control
and modify using your TV and mobile devices. To begin installing your SAGE Beeper Repeater, follow the instructions below.
2
Select Settings.
1
Using your SAGE remote, press HOME.
3
5
6
Select Add Devices.
Select Beeper.
Follow the SAGE Hub on-screen prompts to install
and set up your SAGE Beeper Repeater, pair it, and
establish the rules for it.
IMPORTANT SAFETY NOTICE: The installation instructions
on your SAGE Hub include important safety information. Do
not begin installation of your sensor until you have carefully
reviewed this information. Installation of your device without
reviewing these instructions may result in electric shock, which
could cause injury or death.
4
Select Other.
REPLACING THE BATTERIES
When the Low Battery Warning appears for the SAGE Beeper Repeater, use these instructions to replace the battery.
Note: The SAGE Beeper Repeater takes a set of four (4) NiMH rechargeable batteries.
Note: Dispose of NiMH batteries at a retail recycling drop-off in accordance with local codes.
1
Remove the rear battery cover by lifting up the bottom
of the cover and gently pulling it off (see figure 1).
2
Remove and then dispose of existing batteries properly
(see figure 2).
3
Slide a pair of batteries into each side compartment,
ensuring the each pair’s polarity is correct (see figure 3).
4
Replace the rear battery cover by slotting it correctly in
the case and gently pushing it closed (see figure 4).
5
You may need to re-pair the Beeper Repeater with
the SAGE Hub.
1
3
2
4