User's Guide

SETUP AND INSTALLATION
This sensor allows you to set-up and control up multiple sensors using Zigbee signals that communicate with your SAGE Hub and that you
can control and modify using your TV and mobile devices. To begin installing your SAGE Door/Window Sensor, follow the instructions below.
2
Select Settings.
1
Using your SAGE remote, press HOME.
3
5
6
Select Add Devices.
Select Door/Window Sensor.
Follow the SAGE Hub on-screen prompts to install and
set up your SAGE Door/Window Sensor, pair it, and
establish the rules for it.
IMPORTANT SAFETY NOTICE: The installation instructions
on your SAGE Hub include important safety information. Do
not begin installation of your sensor until you have carefully
reviewed this information. Installation of your device without
reviewing these instructions may result in electric shock, which
could cause injury or death.
4
Select Sensors.
REPLACING THE BATTERY
When the Low Battery Warning appears for the SAGE Door/Window Sensor, use these instructions to replace the battery.
Note: The SAGE Door/Window Sensor takes a CR2032 3V Lithium battery.
Note: Dispose of used batteries at a retail recycling drop-off in accordance with local codes.
1
Remove the front cover by grasping grips toward the top
of the cover and gently pulling outward (see figure 1).
2
Remove the battery by lifting up on its lower right side,
and then dispose of the battery properly (see figure 2).
3
Slide the new battery under the ledge on the left side of
the terminal, ensuring polarity is correct (see figure 3).
4
Replace the front cover by slotting it correctly in the side
rails and then pushing it closed (see figure 4).
5
You may need to re-pair the sensor with the SAGE
Hub.
1
3
2
4