Instruction Manual

STEP 4:

Use an impact drill and #2 Phillips bit to attach the P-BUA-TRANSIT-T ground ring to

the vehicles chassis with a 1/2” self tapping fastener

STEP 3:

Use an impact drill and 10mm nut-setter to install a compatible backup alarm on the

underside of the vehicle

Note: (2) 10mm TEK screws are provided with the compatible backup alarm

STEP 6:

Test the backup alarm

STEP 5:

Plug the backup alarm connector into the mating connector on the P-BUA-TRANSIT-T

harness. Secure any excess wiring with cable ties. Use diagonal cutters to remove

excess cable tie material.