Installation Guide

7
Installation Guide
7
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
Step 1
Select a location for the Camera/Video
Interface. Behind the glove box or below
the radio are both good locations. Ideally,
the location should be within two feet of the
monitor being used. Run the USB extension to
a desired position to access the USB port for
DVR recordings. Once all the connections are
made, two sided tape can be used to secure
the module or you can secure with screws.
Step 2
Select a location for the Display Mode Switch
and IR Receiver. The Display Mode Switch
should be easily reached by the driver. The IR
Receiver should be in the general area of where
the IR Remote Control will be used. Mount both
the switch and the IR Receiver. Route the wire
harness to the video interface and plug it in the
appropriate port.
EMUBCAMKIT
Universal Quad View Camera Kit
Installation