Installation Guide

5
Installation Guide
5
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
Camera/Video Interface Layout
EMUBCAMKIT
Universal Quad View Camera Kit
Yellow- Connect to Constant +12V
Red - Connect to Switched +12V
Black - Connect to Ground (-)
Pink - Camera 4 Trigger (+)
Orange - Camera 3 Trigger (+)
Green - Camera 2 Trigger (+)
White - Camera 1 Trigger (+)
8-Pin Power/Trigger Plug
Remote IR Receiver
Camera Triggers 1-4
Display Mode Switch
USB port
DIP Switches
Required for DVR Recording.
128GB Max Size
Switches between cameras
and display modes.
When +12V is applied, displays
corresponding camera.
Receives signal from the
wireless remote control.
DIP switches 1-4
When in the OFF(DOWN) postion, the camera image will be normal (Non-Mirrored).
Non-Mirrored should be used for any forward facing cameras.
When in the ON (UP) postion, the camera image will reversed (Mirrored).
Mirrored should be used for any rear facing cameras.
DIP switch 5
AHD 25fps, NTSC, PAL. See page 15 for setting video output.
Front
Cam1
Left
Cam2
Rear
Cam3
Right
Cam4
Video-Out
1 2 3 4 5 6
ON