Installation Guide

One of outputs (AHD or CVBS) will
connect to the AVS21 or directly
to the monitor source.
Used to switch (trigger) the monitor to
camera source if manual camera activation
is not available on the monitor source.
15
Installation Guide
15
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Trigger Wires
Setting the Video Output
The four trigger wires on the 8-pin Power/
Trigger plug can be uses to manually activate
each of the four cameras. When a trigger wire
receives +12V, the corresponding camera will
be displayed.
These can be connected to switches to
instantly turn on a selected camera.
The video interface can output four different
video signals: AHD 30 fps, AHD 25 fps, CVBS
NTSC and CVBS PAL. The default setting on
initial power up is CVBS NTSC. To change the
default video signal adjust Dip switches to the
chart on the right.
Orange - Camera 3 Trigger (+)
Green - Camera 2 Trigger (+)
8-Pin Power/Trigger Plug
DEFAULT SETTING:
DIP 5 OFF 6 ON:
CVBS NTSC
DIP 5 OFF 6 OFF:
CVBS PAL
DIP 5 ON 6 OFF:
AHD 25FPS
DIP 5 ON 6 ON:
AHD 30FPS
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
1 2 3 4 5 6
ON
5 6
5 6
5 6
5 6