Installation Guide

11
Installation Guide
11
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Wiring Guide
Step 1
On the 8-pin Power/Trigger plug:
A- Connect the Black wire to Ground
B- Connect the Red wire to Accessory +12V. (A source that turns ON-OFF with the key)
C- Connect the Yellow Wire to Constant +12V
There are several different ways to connect the video interface to your monitor source. We have
included several Wiring Diagrams. NOTE: If you are connecting to an after-market radio, you may
need to remove the radio or refer to the radios owners manual to determine how to wire the video
interface.
All installations require the power/ground connections in Step 1 below. After that, proceed to the
Wiring Diagram that best matches your installation.
1 2 3 4 5 6
ON
A
B
C
If installing in a vehicle with an after-market
radio, the power/ground connections can
be made behind the radio.
NOTE
Trigger Wires
See Page 15