Installation Guide

10
Installation Guide
10
tel - 1-800-477-2267
email - [e-mail]
Illustrations are typical and may not match exact vehicle detail
EMUBCAMKIT
Universal Quad View Camera Kit
Installation (continued)
Front
Cam1-in
Rear
Cam2-in
Left
Cam3-in
Right
Cam4-in
Video-out Reset
Step 5
For each camera; plug in a Camera Input
Adapter (1) into the video interfaces camera
input. Align the arrows on the Camera Input
Adapter and Camera Extension Cable (2) and
connect the cables.
Step 6
DIP switches 1-2-3-4 on the side of the module
correspond to Camera Inputs 1-2-3-4. For any
camera that is facing towards the rear of the vehicle,
set the DIP switch to the ON (UP) position. This will
“mirror” the video so it is viewed correctly on the
monitor.
DIP switch 5 and 6 sets the Video Output Type:
See page 15 for setting video output once unit is
installed.
1
2
1 2 3 4 5 6
ON
ON (UP) = Mirrored
OFF (DOWN) = Non Mirrored