User's Manual Part 10

26
Good practice tips (continued)
When using LeakfinderRT in pinpointing mode, measure the distance between the leak
sensors accurately, e.g., using a frequently calibrated measuring wheel.
Before excavating a leaking pipe, always confirm by listening with a ground mic the location of
the leak position predicted by the correlator.
Some computer brands have a power management tool which if ON may limit the soundcard
operation to MONO mode to conserve power. It’s recommended to edit the computer’s
power management profile to exclude the soundcard or to disable power management
altogether.
Handling sensors while they are powered ON can permanently damage them. Press the
transmitter’s power ON button only after the accelerometer has been attached to the pipe and
press the power OFF button before detaching the sensor from the pipe.
Use care when inserting or removing cable connectors. Also, keep connectors clean, e.g., by
not placing them on loose soil. Rough handling can damage the connectors or their sockets.
To prolong the life of cable connectors and sockets, minimize the frequency of
connecting / disconnecting them.
For prolonged battery life and for achieving the highest possible charge level, charge the
hardware’s batteries at room temperature overnight.
Page 17