User manual

20 X7504083607

OPERATION TC-210

TILLING - Recommended tilling depth is 15-20 cm (6 - 8

inches)

Install Tines with individual tines angled forward, toward front of

unit. (See Tine Removal/Cleaning/Installation)

• Use a forward/backward motion to till soil. Allow tines to dig

into soil, then pull unit back to break up and pulverize clumps.

Tilling depth is controlled by the number of times the

forward/backward motion is used in an area.

• Controlling tilling depth :

• Shallow tilling: Move tiller over soil surface quickly. Tines should be in cultivating position.

• Deeper tilling: Move tiller over soil slowly. Allow tiller to work the same area until desired depth is reached.

• Big Weeds/Tough Roots: Rock tiller back and forth over tough spot until the tines slice through the roots or

weeds.

• Digging Holes: Hold tiller in place, and allow tines to dig down

into the soil. Allow tines to dig approximately 6 – 8 inches

deep, then lift unit up and out. Remove loose soil with shovel

or rake. Resume digging with rotating tiller tines until desired

depth is reached.

CULTIVATING – Recommended cultivating depth is 5-7.5

cm (2 – 3 inches). Install Tines with individual tines angled

rearward, toward the operator.

(See Tine Removal/Cleaning/Installation) Allow unit to move

forward slowly. Pull unit back to cut vegetation and cultivate soil

to desired depth. Repeat forward/backward motion as needed.

TILLING

CULTIVATING