Use and Care Manual

SRM-3020 MAINTENANCE

X7502350000 39

ENGLISH

Gear Housing

1. Clean all loose debris from gear

case.

2. Remove plug (A) and check level

of grease.

3. Add grease if necessary. DO

NOT over-fill.

Drive Shaft

1. Loosen screw (B) and remove

locating screw (C). Pull gear case and shieldfrom drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and re-coat

with 15 ml (0.5 oz.) of grease.

3. Slide the flexible cable back in the drive housing. DO NOT get dirt on

the flex cable.

4. Install the gear housing and shield assembly.

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed

head disassembly is not

necessary. However, if circumstances require disassembly,

follow these instructions.

1. Press top of locking tabs (A) on

both sides of Speed Feed

head to release cover (B) from

eyelet carrier (C).

2. Remove cover from eyelet

carrier.

Nylon Line Replacement

Wear gloves or personal injury may result:

◆ Cutoff knife is sharp.