Use and Care Manual

Gr a s s Tr i m m e r /Br u s h Cu T T e r

Op e r a T O r 's ma n u a l

u-h a n d l e I n s t a l l a t I o n

Tools Required: 17 & 19 mm wrench, Torx T27 L-Wrench,

Parts Required: U-Handle, Clamp w/screws, 8 mm x 55 mm hex

bolt, 8 mm at washer

1. Install upper U-Handle and bracket on lower bracket with one

(1) 8mm x 55mm bolt (A) and (1) large circular washer. Do not

tighten bolt securely until nal adjustments are completed.

2. Loosen upper (2) U-handle clamp screws (B), and position U-

handle as shown.

3. Lightly tighten 8mm bolt (A) and clamp screws (B) to hold U-

handle in position until nal adjustments are completed.

4. Route throttle linkage and ignition lead assembly along shaft and

clip as shown.

t h r o t t l e l I n k a g e a n d I g n I t I o n l e a d s

1. Close choke and remove air lter cover.

2. Place throttle linkage (A) into adjustment xture (B) and install

wire end into large carburetor throttle swivel hole (C). Check

throttle for freedom of movement and that wide open throttle / low

idle extremes are adjusted properly. The throttle linkage must be

adjusted by moving the adjustment nut (D). Consult with your

Echo Dealer for correct adjustment procedure.

4. Tighten nut (E).

5. Connect 2 ignition stop leads F,G) from throttle cable tubing to 2

ignition leads (F,G) on engine.