Use and Care Manual

EMISSION CONTROL SHC-2620

12 X7502342001

• Check that the cutting attachment is firmly attached and in

safe operating condition. Dull, loose or damaged blades

should not be used.

Moving parts can amputate fingers or cause severe injuries.

Keep hands, clothing and loose objects away from all openings.

• ALWAYS stop engine, disconnect spark plug, and make

sure all moving parts have come to a complete stop before

removing obstructions, clearing debris, or servicing unit.

• DO NOT start or operate unit unless all guards and

protective covers are properly assembled to unit.

• NEVER reach into any opening while the engine is running.

Moving parts may not be visible through openings.

Periodically check fuel system (fuel lines, vent, grommet, fuel

tank, and fuel cap) for leaks especially if the unit is dropped. If

damage or leaks are found, do not use unit, otherwise serious

personal injury or property damage may occur. Have unit re-

paired by an authorized servicing dealer before using.

EMISSION CONTROL . (EXHAUST & EVAPO-

RATIVE)

CARB And EPA Emissions Control Information

The emission control system for the

engine is EM (engine modification)

and, if the second to last character

of the Engine Family on the Emis-

sion Control Information label (sam-

ple below) is “B”, “C”, “K”, or “T”, the

emission control system is EM and

TWC (3-way catalyst). The fuel tank/

fuel line emission control system is

EVAP (evaporative emissions). Evaporative emissions for California models

are only applicable to fuel tanks.