Pole Saw User Manual

ManualsBrandsEcho ManualsPole SawPPT-265H

Po w e r Pr u n e r

oP e r a T o r 's Ma n u a l

WARNING

Moving parts can amputate ngers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete

stop before removing obstructions, clearing debris, or servicing unit.

ma I n t e n a n c e

Your ECHO Power Pruner

is designed to provide many hours of trouble free service. Regular scheduled maintenance

will help your pruner achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to

take your unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOUR-

SELF or have the ECHO Dealer do it, each maintenance task has been graded. If the task is not listed see your ECHO

Dealer for repairs.

s k I l l l e v e l

Level 1 = Easy to do. Common tools may be required.

Level 2 = Moderate difculty. Some specialized tools may be required.

ECHO offers REPOWER

Maintenance Kits and Parts to make your maintenance job easier.

m a I n t e n a n c e I n t e r v a l s

COMPONENT / SYSTEM

MAINTENANCE

PROCEDURE

REQ'D

SKILL

LEVEL

DAILY OR

BEFORE

USE

EVERY

REFUEL

3 MONTHS

OR 90

HOURS

YEARLY 600

HOURS

Air Filter Inspect/Clean 1

I / C * R *

Choke Shutter Inspect/Clean 1

I / C

Fuel Filter Inspect/Replace 1

I * I / R *

Fuel Cap Gasket Inspect/Replace 1

I * R *

Fuel System Inspect/Replace 1

I (2) * I (2) *

Spark Plug Inspect/Clean/Replace 1

I/C/R *

Cooling System Inspect/Clean 2

I / C

Muffler Spark Arrestor Inspect/Clean/Replace 2

I/C/R *

Cylinder Exhaust Port Inspect/Clean/Decarbon 2

I / C

Drive Shaft (Flex Cable

Models

)

Inspect/Grease

I (1)

Guide Bar / Sprocket Nose Inspect/Clean/Lubricate 2

I / C * I

Saw Chain

Inspect/Sharpen/

Replace/Tension

I * I *

Recoil Starter Rope Inspect/Clean 1

I / C *

Screws/Nuts/Bolts Inspect/Tighten/Replace 1

I *

(2) Low evaporative fuel tanks DO NOT require regular maintenance to maintain emission integrity.

* All recommendations to replace are based on the finding of damage or wear during inspection.

MAINTENANCE PROCEDURE LETTER CODES:

I = INSPECT, R = REPLACE, C = CLEAN

IMPORTANT NOTE

- Time intervals shown are maximum. Actual use and your experience will determine the

frequency of required maintenance.

MAINTENANCE PROCEDURE NOTES:

(1) Apply POWER BLENDX

lubricant every 25 hours of use.