Pole Saw User Manual
Table Of Contents
- Introduction
- Table of Contents
- Safety
- Emission Control (exhaust & evaporative)
- Description
- handle shaft / power head
- throttle linkage and ignition leads
- cutting attachment to drive shaft installation
- saw chain tension adjustment
- Operation
- fuel
- lubricating the guide bar and saw chain
- adjusting automatic oiler
- starting cold engine
- starting warm engine
- stopping engine
- pruning techniques
- Maintenance
- air filter
- fuel filter
- spark plug
- cooling system cleaning
- exhaust system
- carburetor adjustment
- guide bar and saw chain replacement
- filing saw chain
- Troubleshooting
- Storage
- Specifications
- Warranty Statements
- Servicing Information
Po w e r Pr u n e r
TM
oP e r a T o r 's Ma n u a l
21
s t a r t I n g w a r m e n g I n e
The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not depress throttle trigger to wide open position.
WARNING
The attachment should not move at idle, otherwise serious personal
injury may result.
NOTE
If attachment moves, readjust carburetor according to “Carburetor
Adjustment” instructions in this manual or see your ECHO Dealer.
1. Stop Switch.
Move Stop Switch button (A) forward away from the STOP posi-
tion.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible and ows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter.
Lay the unit on a at, clear area and rmly grasp right hand grip
with left hand. Do not depress throttle trigger. Pull the recoil
starter handle (D) until the engine res.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
C
d
D
A
A
PPT-265
PPT-265S/H
PPT-265
PPT-265S/H