Use and Care Manual

MAINTENANCE PPF-2620
38 X7507820500
© 10/2017 ECHO Inc.
Note: Every unit is run at the
factory and the carburetor
is set in compliance with
emission regulations.
Carburetor adjustments,
other than idle speed,
must be performed by an
authorized dealer.
1. Check idle speed and reset if
necessary. If a tachometer is
available, idle speed screw (A)
should be set to the
specifications found on
“Specifications” page of this
manual. Turn idle screw (A)
clockwise to increase idle speed; counterclockwise to decrease idle
speed.
Lubrication
Drive Shaft
Level 1.
1. Remove cutting attachment
locater screw (A).
2. Loosen two bolts (B).
3. Remove cutting attachment
assembly.
4. Remove flex cable (C), wipe
clean and apply 15 ml (0.5 oz.)
of lithium based grease.
5. Slide the flexible cable back in
the drive housing. DO NOT get
dirt on the flex cable.
6. Install and secure cutting
attachment assembly.
Parts Required: Lithium Based Grease
A
A
A
C
B