Use and Care Manual

ASSEMBLY PPF-2620

20 X7507820500

To Adjust Saw Chain Tension

1. Move stop switch to STOP

position.

2. Disconnect spark plug lead.

3. Loosen two guide bar nuts (A)

until finger tight.

Always loosen guide bar nuts before turning the chain tension

adjuster, otherwise the clutch cover and tensioner will be damaged.

4. Hold the bar nose up, and turn

the adjuster screw (B)

clockwise until the chain fits

snugly against the underside of

the bar, as shown. Cold Chain

Only - turn adjuster screw CW

an additional 1/8 - 1/4 turn.

Tighten both guide bar nuts

with nose held up. Tighten rear

nut first.

5. Pull the chain around the guide

bar by hand. Reduce the chain tension if you feel tight spots.

6. When chain is properly tensioned, tighten guide bar nuts securely.

Tighten guide bar nuts to 8 - 9 N•m (71 - 80 in. lbs.). DO NOT over-

tighten nuts or damage may result.

7. Keep chain properly tensioned at all times.

Note: All chains require frequent adjustment.

8. Connect spark plug lead.