Use and Care Manual

PE-2620/S OPERATION

X7502350201 23

4. Loosen adjustment knob (A).

Move wheel (B) up to increase

cutting depth, or down to

decrease cutting depth. A depth

of 0.5 in. (13 mm) is optimal.

Tighten adjustment knob (A).

5. Before edging, plan your

direction of travel so that the

unit will always be positioned

on your right side and so that

you walk on a hard surface

whenever possible.

6. Position edger as shown.

Before edging, be sure to read and understand the entire

Operator's Manual to avoid serious injury.

7. When starting to edge, run the engine at full throttle, and lower the

blade gently into the ground, being careful not to hit the concrete with

the blade.

8. Don't force the blade. Move only as quickly as the blade will allow.

The complete unit, specifically the drive shaft

assembly and muffler exhaust area may

become very hot during use. Avoid contact

during and immediately after operation, otherwise serious

personal injury may result.