Use and Care Manual

X7502341200 27

PE-2620 MAINTENANCE

ENGLISH

IMPORTANT NOTE - Time intervals shown are maximum. Actual use and your

experience will determine the frequency of required maintenance.

* Replacement is recommended based on the finding of damage or wear during

inspection

MAINTENANCE PROCEDURE NOTES:

(1) Apply lithium based grease every 25 hours of use.

(2) Apply lithium based grease every 50 hours of use.

Air Filter

Level 1

1. Close choke (COLD START [ ] position). This prevents dirt from

entering the carburetor throat when the air filter is removed. Brush

accumulated dirt from air cleaner area.

2. Remove air filter cover. Brush dirt from inside cover.

3. Remove foam pre-filter and air

filter and clean as indicated

below:

Foam Pre-filter

• Clean foam filter in water/

detergent solution and rinse

with clean water.

• Wrap the filter in a clean, dry

cloth and squeeze (do not

wring) dry. Allow to dry

completely before reuse. Do

not oil.

Air Filter

• Lightly brush debris from filter. Replace filter if it is damaged, fuel soaked,

very dirty, or the rubber sealing edges are deformed.

4. Assemble components in reverse order.

Fuel Cap Gasket Replace* 1

Parts Required:

REPOWER

AIR & FUEL FILTER KIT.

COMPONENT/SYSTEM

MAINTENANCE

PROCEDURE

REQ’D

SKILL

LEVEL