Use and Care Manual
Table Of Contents
- Operator’s Manual PB-9010 H/T Power Blower
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Emission Control
- (Exhaust & Evaporative)
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
PB-9010 H/T OPERATION
X7501200700 29
© 08/20 ECHO Incorporated
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the
choke.
1. Throttle Lever
Move throttle lever (A) to IDLE
position.
2. Purge Bulb
Pump purge bulb (C) until fuel is
visible. Pump bulb an additional
4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (D) and
engine should start. Do not use
choke (B).
Note: If engine does not start
after 5 pulls, use cold
start procedures.
PB-9010 H
A
PB-9010T
A
D
B
C