Use and Care Manual

PB-760 LN H/T OPERATION

X7531125902 21

Starting Cold Engine

• Recoil starter: Use short pulls - only 1/2 - 2/3 of rope length for starting. Do not allow the rope to snap back

in. Always hold the unit firmly.

• (PB-760 LN H): Rotate spring loaded throttle arm downward to a comfortable operating position.

1. Throttle Position Lever

Move Throttle Position Lever (A) to IDLE position.

2. Choke

Move choke (C) up to COLD START ( ) position.

3. Purge Bulb

Pump purge bulb (D) until fuel is visible. Pump bulb an

additional 4 or 5 times.

4. Recoil Starter

Pull recoil starter handle (E) until engine fires, or a maximum

of 5 pulls.

5. Choke

After engine fires (or 5 pulls), move choke lever back to RUN

( ) position, then pull starter handle/rope until engine starts

and runs. Allow unit to warm up at idle for several minutes.

Note: If engine does not start with choke in RUN position after 5

pulls, move choke to COLD START ( ) position, and

repeat steps 4 & 5.

6. Throttle Position Lever

Allow engine to warm up for several minutes before use.

7. Throttle Position Lever

After engine warm-up, move Throttle Position Lever gradually to increase engine RPM to desired operating

speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO

NOT close the choke.

1. Throttle Position Lever

Move Throttle Position Lever (A) to IDLE position.

PB-760 LN H

PB-760 LN T

PB-760 LN H

PB-760 LN T