Use and Care Manual

PB-760 LN H/T ASSEMBLY

X7531125902 17

Note: Blower use will eventually loosen pipe connections.

Exclusive positive locking system allows pipes to be

tightened. If loosening occurs, remove two straight pipes

and install according to instructions 7 & 8.

PB-760LN T

Never perform maintenance or assembly procedures with engine running or serious personal injury

may result.

Install Blower Pipes

1. Assemble clamps (A) and (G) onto both ends of flexible pipe

(B).

Note: Clamp with cable guide loop (G) fits elbow end of flexible

pipe.

Note: A light lubricant may be used to ease assembly of flexible

pipe to blower elbow.

2. Assemble flexible pipe to elbow (D) on blower. Position

clamp with cable guide loop (G) on outside of flexible pipe

and tighten clamp.

Note: Hang handle freely from blower to assure throttle cable is

not twisted before installing handle (E).

3. Position throttle cable along the outside of elbow. Loosen

knob (H) on handle (E). Align notches in handle with tabs (F)

and install onto swivel pipe (C) past long ridges in pipe.

4. Assemble swivel pipe into flexible pipe and tighten clamp

(A).

5. Clip throttle cable into throttle cable guide loop.

For more information

scan this QR code.