Use and Care Manual

assembly

WARNING

Never perform maintenance or assembly procedures with engine

running or serious personal injury may result.

InsTall blower pIpes / sTICk handle

1. Assemble clamps (A) onto both ends of exible pipe (B).

2. Assemble swivel pipe (C) into exible pipe (B) and tighten clamp

(A).

3. Assemble exible pipe (B) to elbow (D) on blower and tighten

clamp (A).

NOTE

A light lubricant may be used to ease assembly of exible pipe to

blower elbow.

4. Loosen wing nut (E) completely and open stick handle clamp.

5. Align notches (F) in handle clamp with tabs (G).

6. Slide stick handle onto swivel pipe (C). Stick handle should be

angled away from operator.

7. Position stick handle (H) for comfortable operation, and tighten

wing nut (E).

8. Assemble straight pipe (I) onto swivel pipe (C), until you feel

light resistance. Do not force connection. Hold swivel pipe and

turn straight pipe counter clockwise, engaging positive locking

channels,until connection is rm. Do not force connention.

9. Assemble straight pipe with decal (J) to straight pipe (I) as in step

NOTE

Blower use will eventually loosen pipe connections. Exclusive

positive locking system allows pipes to be tightened. If loosening

occurs, remove two straight pipes and install according to instruc-

tions 8 & 9.