Use and Care Manual

PB-2520 OPERATION

X7501190001 21

ENGLISH

3. Choke

Move choke (C) to COLD START

( ) (closed) position.

4. Purge Bulb

Pump purge bulb (D) until fuel is

visible and flows freely in the

clear fuel tank return line.

Recoil starter: Use short pulls - only 1/2 to 2/3 of rope for starting. Do

not allow the rope to snap back in. Always hold the unit firmly.

5. Recoil Starter

Place the unit on a flat, clear

area. Firmly grasp throttle

handle (E) with left hand and

rapidly pull recoil starter handle

(F) until engine fires, or

maximum 5 pulls.

6. Choke

Move choke lever (C) to RUN

position ( ), and if necessary,

restart engine.

Note: If engine does not start with choke in RUN position after 5

pulls, repeat instructions 3 - 6.

7. Throttle Trigger

After engine warm up, gradually depress throttle trigger to increase

engine RPM to operating speed.

Note: Allow engine to warm up 3 minutes before use.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the

choke.