User Manual

LC-56V2A

9992220571412

If the battery does not charge correctly:

1. Test outlet by plugging a different appliance into it.

2. Assure that the charger contacts are not short-circuited.

3. If the charger is not under usual room temperature, move charger and

battery to a location that is between 6 ˚C (42.8 °F) and 40˚C (104 °F).

Examine The Charger

OPERATION

Incorrect Defect Note:

1. Put the battery into the charger.

• If the status LED1 ashes red, remove the battery from the charger for 1

minute.

2. Put the battery into the charger again.

• If the status LEDs show correct, the battery is good.

• If the status LED1 stays blinking red, remove the battery and disconnect

the charger.

3. Wait for 1 minute and put the battery into the charger again.

• If the status LEDs show correct, the battery is good.

• If the status LED1 stays blinking red, the battery is defective and must be

replaced.

If charging is attempted in an environment that's too hot,

charger LED will turn red. Remove battery and allow to cool for

approximately 30 minutes.