Operator's Manual
Table Of Contents
- Operator’s Manual HC-2020 Hedge Trimmer
- Table of Contents
 - Introduction
 - Servicing Information
 - Safety
 - Emission Control
 - (Exhaust & Evaporative)
 - Description
 - Contents
 - Assembly
 - Operation
 - Maintenance
 - Troubleshooting
 - Storage
 - Specifications
 - Product Registration
 
 
HC-2020 MAINTENANCE
X7702245301 33
© 11/19 ECHO Incorporated
Carburetor Adjustment
The blades must not move at idle, otherwise serious personal 
injury may result. Periodic carburetor adjustment may be 
necessary to assure blades do not move at idle. 
If blades move, readjust carburetor according to these 
instructions, or see your ECHO Dealer. 
Engine Break-In
New engines must be operated a minimum duration of two tanks of fuel 
break-in before carburetor adjustments can be made. During the break-in 
period your engine performance will increase and exhaust emissions will 
stabilize. Idle speed can be adjusted as required.
High Altitude Operation
This engine has been factory adjusted to maintain satisfactory starting, 
emission, and durability performance up to 1,100 feet above sea level (ASL) 
(96.0 kPa). To maintain proper engine operation above 1,100 feet ASL the 
carburetor may
 need to be adjusted by an authorized ECHO service dealer.
If the engine is adjusted for operation above 1,100 feet ASL, the 
carburetor must be re-adjusted when operating the engine below 
1,100 feet ASL, otherwise severe engine damage may result.
Level 2.
Note:  Every unit is run at the factory and the carburetor is set in 
compliance with emission regulations. Carburetor 
adjustments, other than idle speed, must be performed by an 
authorized ECHO dealer.
Parts Required: None










