Use and Care Manual

14 X7732272400

ASSEMBLY GT-225SF

ASSEMBLY

Plastic Shield Installation

Cut-off knife on debris shield has sharp edges. Avoid contact when installing or removing line head.

Wear Gloves or personal injury may result:

◆ Cut-off knife is sharp.

◆ Gear case and surrounding area may be hot.

1. Remove wing nut (A), washer (B), and bolt (C).

2. Snap the shield over the bearing housing.

3. Install bolt (C), washer (B), and wing nut (A).

Support Handle

Note: Label shows minimum spacing for Support Handle

location.

Note: Support Handle is pre-installed. Re-positioning and

tightening is all that is required.

1. Position Support Handle (A) in comfortable operating

position and tighten wing nut (B). The cutting attachment

should be 5 - 7.5 cm (2 - 3 in.) above the ground and as

level as possible.

Parts Required: Plastic Shield Assembly.

MIN

SPACING