Use and Care Manual

11
MAINTENANCE AND CARE
IMPORTANT
Time intervals are maximum. Actual use and
your experience will determine the frequency
of required maintenance.
Record dates of monthly and yearly
inspections.
AREA MAINTENANCE PAGE BEFORE MONTHLY YEARLY DATE
USE MAINTENANCE
PERFORMED
Air Filter Clean/Replace 13 •
Fuel Filter Inspect/Clean/
13 •
Replace
Spark Plug Inspect/Clean/
13 •
Adjust/Replace
Carburetor Adjust 14 •
Cooling System Inspect/Clean 15 •
Silencer Inspect/Tighten/
Clean 15 •
Starter Rope Inspect/Replace - •
Drills Inspect/Clean/
-•
Lubricate
Fuel Leaks Inspect 13 •
Screws, Bolts and Inspect,
Nuts Tighten/Replace
-•
Fuel Line Inspect - •
EMISSION DATA
EMISSION CONTROL
(EXHAUST and EVAPORATIVE)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM
(engine modifi cation) and, if the second to last
character of the Engine Family on the Emission
Control Information label (sample below) is "C", "K",
or "T",the emission control system is EM and TWC
(3-way catalyst). The fuel tank/fuel line emission
control system is EVAP (evaporative emissions).
Evaporative emissions for California models may
only be applicable to fuel tanks.
An Emission Control Label is located on the
engine. (This is an example only, information on
label varies by engine family).
PRODUCT EMISSION DURABILITY (EMISSION
COMPLIANCE PERIOD)
The 300 hours emission compliance period is the
time span selected by the manufacturer certifying
the engine emissions output meets applicable
emissions regulations, provided that approved
maintenance procedures are followed as listed in
the Maintenance Section of this manual.