Full Product Manual
Table Of Contents
- Operator’s Manual DPPF-2100 Power Pruner®
- Table of Contents
- Introduction
- Servicing Information
- Safety
- For safe use of your product
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Kickback
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
OPERATION DPPF-2100
30 X7508310400
© 8/23 ECHO Incorporated
• When ready to cut, hold the
cutting shoe against the branch.
This will prevent whipping of the
branch. DO NOT use back and
forth sawing action.
• Look out for branches
immediately behind the branch
being cut. If saw chain hits a rear
branch damage to the saw chain
and guide bar may occur.
• Accelerate to full speed.
• Ease cutting pressure when
nearing end of cut to maintain
control.
• When pruning a limb 102 mm
(4 in.) diameter or larger cut as
follows:
1. Under cut 1/4 limb diameter
near tree trunk.
2. Finish top cut slightly farther
out on limb.
3. Flush cut stub at trunk.
• DO NOT use for felling or
bucking.
Cutting shoe against branch
Correct
Cutting shoe away from branch
Not Correct
Blade hits rear branch
Not Correct