Full Product Manual
Table Of Contents
- Operator’s Manual DPPF-2100 Power Pruner®
- Table of Contents
- Introduction
- Servicing Information
- Safety
- For safe use of your product
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Kickback
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
DPPF-2100 ASSEMBLY
X7508310400 21
© 8/23 ECHO Incorporated
Saw Chain Adjustment
Always remove battery before servicing cutting attachment.
Wear gloves when handling saw chain, otherwise serious
personal injury may result.
Saw Chain Adjustment
1. Release power switch to stop
unit.
2. Remove battery.
3. Loosen two guide bar nuts (A)
until finger tight.
Always loosen guide bar nuts before turning the chain tension
adjuster, otherwise the sprocket guard and tensioner will be
damaged.
4. Hold the bar nose up, and turn the adjuster screw (B) clockwise until
the chain fits snugly against the underside of the bar, as shown. Cold
Chain Only - turn adjuster screw CW an additional 1/8 - 1/4 turn.
Tighten both guide bar nuts with nose held up. Tighten rear nut first.
5. Pull the chain around the guide bar by hand. Reduce the chain tension
if you feel tight spots.
6. When chain is properly tensioned, tighten guide bar nuts securely.
Tighten guide bar nuts to 8 - 9 N•m (71 - 80 in. lbs.). DO NOT over-
tighten nuts or damage may result.
A
B