Use and Care Manual

DPAS-2600SB ASSEMBLY
X7508230800 17
©11/21 ECHO Incorporated
ASSEMBLY
Support Handle Installation
Note: Label shows minimum
spacing for support
handle location.
1. If necessary, position support
handle for comfortable
operation and securely tighten
screws.
Power Head Shaft to Lower Shaft Assembly
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locater pin (A) out, and turn counterclockwise one-quarter turn to
lock-out position.
3. Remove storage hook and cap from attachment drive shaft.
Note: Your coupler may appear different than coupler shown.
Earlier model power heads may have shorter couplings.
4. Carefully fit attachment drive
shaft assembly into coupler (B).
Rotate shaft (C) to make sure
inner lower drive shaft engages
square upper drive shaft
socket.
Note: Lower bearing housing
and head assembly must
be in line with power
head.
Note: Some models have an
assembly line decal to assist in assembly.
5. Rotate locater pin (A) one-
quarter turn clockwise to
engage lower shaft hole. Make
sure locater pin is fully engaged
by rotating lower drive shaft.
Locater pin should snap flush in
coupler. Full engagement will
prevent further shaft rotation.
6. Secure lower shaft assembly to
coupler by tightening clamping
knob (D).