Full Product Manual
Table Of Contents
- Operator’s Manual DPAS-2600 Pro Attachment Series™
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- General Safety Warnings and Instructions for the following ECHO tool: Blower or DPAS unit configured as a Blower.
- General Safety Warnings and Instructions for the following ECHO tools: Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Trimmer, or Articulating Hedge Trimmer, or DPAS unit configured as a Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Tr...
- General Safety Warnings and Instructions for the following ECHO tools: All DSRM and DGT models, and DPAS units configured as trimmers and brush cutters.
- This section contains additional warnings and instructions contained in UL 62841-4-2 and 62841-4- 4.
- For grass trimmers, brush cutters, and brush saws, according to the type of supplied cutting accessory:
- For hedge trimmers:
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
DPAS-2600 MAINTENANCE
X7508230802 49
©10/23 ECHO Incorporated
1. File each tooth at a 30° angle a
specific number of times, e.g.,
four strokes per tooth. Work
your way around the blade until
all teeth are sharp.
2. DO NOT file the ‘gullet’ (radius)
of the tooth with the flat file. The
radius must remain. A sharp
corner will lead to a crack and
blade failure.
If an electric grinder is used, use care not to overheat teeth, do not
allow tips/tooth to glow red or turn blue. DO NOT place blade in
cooling water. This will change the temper of the blade and could
result in blade failure.
3. After sharpening teeth, check
each tooth radius for evidence
of a square (sharp) corner. Use
the round (rat tail) file to renew
the radius.
30º
30º
30º
CUTTING
TOOTH
AREA
CUTTING
TOOTH
RADIUS
GULLET
(RADIUS)