Full Product Manual
Table Of Contents
- Operator’s Manual DPAS-2600 Pro Attachment Series™
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- General Safety Warnings and Instructions for the following ECHO tool: Blower or DPAS unit configured as a Blower.
- General Safety Warnings and Instructions for the following ECHO tools: Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Trimmer, or Articulating Hedge Trimmer, or DPAS unit configured as a Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Tr...
- General Safety Warnings and Instructions for the following ECHO tools: All DSRM and DGT models, and DPAS units configured as trimmers and brush cutters.
- This section contains additional warnings and instructions contained in UL 62841-4-2 and 62841-4- 4.
- For grass trimmers, brush cutters, and brush saws, according to the type of supplied cutting accessory:
- For hedge trimmers:
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
DPAS-2600 OPERATION
X7508230802 37
©10/23 ECHO Incorporated
OPERATION
Starting Unit
The attachment will operate when the battery is installed, the
power indicator LED is lit, and the operator presence switch,
lock off lever switch (if applicable), and power switch are
engaged. Make sure the product is properly positioned to
prevent loss of control and possible serious injury.
Note: This model has three operating modes: low, medium, high.
Use + (E) and - (F) buttons to switch between modes. Power
indicator LED flashes twice when highest or lowest setting is
achieved by pushing + (E) and - (F) buttons. Use power
switch to increase RPM speed within each mode.
1. Keep movable parts of the attachment away from objects that could
become entangled or thrown, and surfaces that could cause loss of
control.
2. Push enable button (A) once
to turn on power to unit.
Power indicator LED (B)
illuminates when power to
unit is turned on.
3. Hold down operator
presence switch (C). Move
lock off lever switch (D)
backward to free power
switch (G), and then depress
power switch to increase
RPM.
C
D
G