Full Product Manual
Table Of Contents
- Operator’s Manual DPAS-2600 Pro Attachment Series™
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- General Safety Warnings and Instructions for the following ECHO tool: Blower or DPAS unit configured as a Blower.
- General Safety Warnings and Instructions for the following ECHO tools: Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Trimmer, or Articulating Hedge Trimmer, or DPAS unit configured as a Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Tr...
- General Safety Warnings and Instructions for the following ECHO tools: All DSRM and DGT models, and DPAS units configured as trimmers and brush cutters.
- This section contains additional warnings and instructions contained in UL 62841-4-2 and 62841-4- 4.
- For grass trimmers, brush cutters, and brush saws, according to the type of supplied cutting accessory:
- For hedge trimmers:
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
DPAS-2600 ASSEMBLY
X7508230802 31
©10/23 ECHO Incorporated
ASSEMBLY
Support Handle Installation
Note: Label shows minimum
spacing for support
handle location.
1. If necessary, position support
handle for comfortable
operation and securely tighten
screws.
Power Head Shaft to Lower Shaft Assembly
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locater pin (A) out, and turn counterclockwise one-quarter turn to
lock-out position.
3. Remove storage hook and cap from attachment drive shaft.
Note: Your coupler may appear different than coupler shown.
4. Carefully fit attachment drive
shaft assembly into coupler (B).
Rotate shaft (C) to make sure
inner lower drive shaft engages
square upper drive shaft
socket.
Note: Lower bearing housing
and head assembly must
be in line with power
head.
Note: Some models have an
assembly line decal to assist in assembly.
5. Rotate locater pin (A) one-
quarter turn clockwise to
engage lower shaft hole. Make
sure locater pin is fully engaged
by rotating lower drive shaft.
Locater pin should snap flush in
coupler. Full engagement will
prevent further shaft rotation.
6. Secure lower shaft assembly to
coupler by tightening clamping
knob (D).