Full Product Manual
Table Of Contents
- Operator’s Manual DPAS-2600 Pro Attachment Series™
- Table of Contents
- Introduction
- Servicing Information
- Safety
- Manual Safety Symbols and Important Information
- International Symbols
- Read the Manuals
- Clear the Work Area
- Keep a Firm Grip
- Keep a Solid Stance
- Handling the Product
- Equipment
- General Safety Warnings and Instructions for the following ECHO tools: Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner, or DPAS unit configured as a Curved Shaft Edger, Straight Shaft Edger, Tiller Cultivator, or Pole Pruner.
- General Safety Warnings and Instructions for the following ECHO tool: Blower or DPAS unit configured as a Blower.
- General Safety Warnings and Instructions for the following ECHO tools: Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Trimmer, or Articulating Hedge Trimmer, or DPAS unit configured as a Hedge Trimmer, Mid-Reach Hedge Trimmer, Shafted Hedge Tr...
- General Safety Warnings and Instructions for the following ECHO tools: All DSRM and DGT models, and DPAS units configured as trimmers and brush cutters.
- This section contains additional warnings and instructions contained in UL 62841-4-2 and 62841-4- 4.
- For grass trimmers, brush cutters, and brush saws, according to the type of supplied cutting accessory:
- For hedge trimmers:
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Warranty
- Product Registration
- Notes
SAFETY DPAS-2600
28 X7508230802
©10/23 ECHO Incorporated
1. Loosen gear case clamping
screw (A) and remove gear
case locating screw (B).
2. Rotate cutter assembly 180° on
drive shaft until locating hole in
drive shaft is visible through
locating hole in gear case.
3. Install gear case locating screw
(B), and securely tighten all
hardware.
Hedge Trimmer blades are very sharp. Wear gloves to protect
hands when rotating cutter assembly or serious personal injury
may result.
During operation, the complete unit, especially the drive shaft
housing and gear case may become too hot to touch. Avoid
contact when rotating cutter assembly.
B
A