Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
SPECIFICATIONS DCS-2500TN
62 X7508220500
© 7/23 ECHO Incorporated
SPECIFICATIONS
These specifications are subject to change without notice.
MODEL DCS-2500TN
Weight without battery, guide bar, saw chain
and chain oil
1.7 kg (3.7 lb.)
External Dimensions: length × width × height
260 × 188 × 209 mm (10.2 x 7.4 x 8.2
in.)
Chain oil capacity 120 mL (4.06 US fl. oz.)
Oiling system Automatic adjustable oiler
Hand guard Front and rear hand guards
Chain brake Manual and non manual band brake
Guide bar and saw chain:
Guide bar .050 in. gauge, sprocket nose
Bar length 12 in.
Saw Chain Oregon 80TXL (3/8 in. pitch)
Sprocket type Spur type, 6-tooth, 3/8 pitch
Chain speed 19.1 m/s
Chain tensioner Side access system
Battery
ECHO eFORCE™ 56V series 2.5
AH batteries
Type Li-Ion
Pack voltage 56 (rated 50.4)
Capacity 2.5 Ah/126 Wh
Charger type
ECHO eFORCE™ 56V series
charger
Charger input voltage 120V AC 60Hz
Charging time See battery manual
Green blinking - battery is charging
Green - battery is fully charged
Red - Battery is too warm. Remove
for approximately 30 minutes to cool
down
Red blinking - Defective battery.
Remove and replace with new
battery
Charger Lights
OFF Green blinking
OFF Green
Red OFF
Red OFF
blinking