Use and Care Manual
Table Of Contents
- Operator’s Manual DCS-2500TN Chainsaw
- Table of Contents
- Introduction
- Safety
- For safe use of your product
- International Symbols
- Location in which the safety decal is attached
- Handling the Product
- Chainsaw Safety Warnings
- Causes and Operator Prevention of Kickback
- Kickback Safety Precautions
- General Precautions
- Precautions for Use
- Users of the product
- Environment of Use and Operation
- Vibration and Cold
- Repetitive stress injuries
- Transport of the product
- Starting the unit
- Once the unit has started, check for abnormal vibrations and sounds.
- Disconnect the battery:
- Do not touch high temperature or high voltage components while the product is running.
- Turn off the unit when checking or maintaining the product.
- Turn off the unit immediately if anything goes wrong.
- A ten meter radius is a danger zone.
- Using the product.
- Make sure that the saw chain is stopped before putting the unit on the ground
- Protective Gear
- Description
- Contents
- Assembly
- Operation
- Maintenance
- Troubleshooting
- Storage
- Specifications
- Product Registration
- Warranty
- Notes
DCS-2500TN MAINTENANCE
X7508220500 55
© 7/23 ECHO Incorporated
1. Depress battery latch
release slide battery out
of saw.
2. Use compressed air or
a soft bristle brush to
remove debris from
battery and battery
compartment.
Oil Filter
1. Do not allow dust to
enter oil tank
2. A clogged oil filter will
affect the normal
lubricating system.
3. Remove filter (A)
through oil filling hole
with a piece of steel
wire or the like.
4. If the oil filter is dirty,
clean it with gasoline or replace it.
5. Install the oil filter as shown.
6. When the inside of the tank gets dirty, rinse the tank out with gasoline to
clean it.
7. Remove debris from O ring and thread of oil tank cap.
Guide Bar
Do not degrease brake drums and brake bands. After cleaning, apply
a thin oil between the brake drum and the brake band.
A